Sens’it USER MANUAL www.sensit.
SUMMARY
SAFETY INSTRUCTIONS 4 I. CONTENT OF THE PACK 4 II. PRESENTATION 5 III. HOW TO START 8 IV. TECHNICAL SPECIFICATIONS 9 V. WARNING STATEMENTS 10 VI.
SAFETY INSTRUCTIONS * Before any use, please read carefully this manual and keep it for any later use. * Any use not in accordance with this manual will result the exclusion of warranty and of the manufacturer’s liability. * Use only parts and components coming from Sigfox and Sens’it. * Place the Sens’it in a cool and dry area. For the withstood temperature and humidity ranges, see the technical specifications. * Do not leave any electronic equipment on the top the Sens’it.
II. PRESENTATION Sens’it is a connected device whose objective is to demonstrate capabilities of Sigfox network. It includes several sensors that will measure data and send it to web and mobile applications available on www.sensit.io THE SENS’IT CAN BE CONFIGURED IN 6 DIFFERENT MODES: * Temperature and Humidity mode (LED blinks in green). In this mode, the Sens’it will send sensors’ data at a defined frequency (every 10min, hour, 6hours, day). * Light mode (LED blinks in yellow).
HOW TO CHANGE MODES AND SEND MESSAGES: * One long press on the central button will make the Sens’it change mode. * On double press and the Sens’it will directly send a message. * On short press and the LED will blinks in the current mode color. CHARGING * To recharge the Sens’it, a micro USB cable is needed. * Once plugged, the secondary RED LED will turn on. It turns off when the battery is completed charged. * The main LED blinks twice in RED to warn user of an empty battery.
Sens’it Temperature & humidity Light Door opening detection Movement or vibration Magnet Alerting 7
ID : D4523 III. HOW TO START Visit www.sensit.
IV. TECHNICAL SPECIFICATIONS THE SENS’IT INCLUDES SEVERAL SENSORS: * Temperature * Humidity * Movement (3-axis accelerometer) * Magnetometer * Light IT ALSO INCLUDES * A central button to control the device * A Reed-switch that goes with the magnet.
V. WARNING STATEMENTS 1. FCC: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. • The radiated output power of the device is far below the FCC radio frequency exposure limits.
• Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. 2. IC This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s).
Contact: contact@sensit.io Do not throw away Sens’it in the normal household trash; it must be disposed properly in the same way as other electronic equipment following official procedures.
