Installation Guide

SENSAPHONE INFRARED MOTION DETECTION SENSOR • FGD-0007-HW
Installation Instructions v4.0
The Infrared Motion Detection Sensor is used to monitor the movement of warm bodies in a specific area.
The range is a maximum of 40 feet directly ahead of, and approximately 25 feet to either side of, the detec-
tor. The sensor requires 12V DC power to operate. Read all of the instructions before installing your sensor.
Follow the recommendations to determine the best location to mount your sensor.
Wiring to Sensaphone
Connect the ’NC’ and ’C’ terminals on the detector to an unused Zone input on your Sensaphone.
Connect 12V DC power from the power adapter to the ‘V+’ and ‘V-‘ terminals. The wire nuts can be
used to splice-in additional wire to the power wires.
Sensaphone Programming
Set the input type on your Sensaphone to Normally Closed with a recognition time of 1 second. See typical
programming sequences below:
• For models 400, 800, 1400, 1800:
To be certain that the normal input state is closed, take a piece of wire and attach it across the input termi-
nals. This will force the input closed. Press Set, then Configure to set the normality.
• For Sensaphone WEB600 and Express II:
Program the input type as normally closed.
SENSAPHONE
®
REMOTE MONITORING SOLUTIONS