Datasheet

ManualsBrandsSensata Crydom ManualsRelaysSolid State Relay Single Phase PCV, SPST-NO, 75A, 280V, Screw Terminal

PCV Series

• Proportional controller

• Ratings from 15A to 90A @ 240 VAC

• 2-7 V DC or 2-10 V DC analog input range

• For use with resistive loads only

PRODUCT SELECTION

A 09A 57A 05A 52A 51noitpircseD

2-7 VDC Control 7PCV2415 7PCV2425

2-10 VDC Control 10PCV2415 10PCV2425 10PCV2450 10PCV2475 10PCV2490

OUTPUT SPECIFICATIONS (1)

A 09A 57A 05A 52A 51noitpircseD

Operating Voltage (47-63Hz) [Vrms] 100-240 100-240 100-240 100-240 100-240

Transient Overvoltage [Vpk] 600 600 600 600 600

Maximum Off-State Leakage Current @ Rated Voltage [mArms] 10 10 10 10 10

Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (2) 200 200 200 200 200

Maximum Load Current (3) [Arms] 15 25 50 75 90

Minimum Load Current [Arms] 0.15 0.15 0.15 0.15 0.15

Maximum Surge Current (16.6ms) [Apk] 150 250 625 1000 1200

Maximum On-State Voltage Drop @ Rated Current [Vpk] 1.6 1.6 1.6 1.6 1.6

Maximum I² t for Fusing (8.3 msec) [A² sec] 94 260 1620 4150 6000

Minimum Power Factor (with Maximum Load) 0.5 0.5 0.5 0.5 0.5

INPUT SPECIFICATIONS (1)

xx42VCP01xx42VCP7noitpircseD

Control Voltage Range 2-7 VDC 2-10 VDC

Typical Input Current @ 5 VDC 4 mA 4 mA

GENERAL SPECIFICATIONS

sretemaraPnoitpircseD

Dielectric Strength, Signal to Load (50/60Hz) 2500 Vrms

Dielectric Strength, Signal to Base 2500 Vrms

Ambient Operating Temperature Range -30 to 80 °C

Ambient Storage Temperature Range -40 to 125 °C

Weight (typical) 3.5 oz. (100g)

Encapsulation Themaly Conductive Epoxy

Terminals Screws and Saddle clamps Furnished, Unmounted

GENERAL NOTES

1) All parameters at 25°C unless otherwise specified.

Datasheet

Control Relays

Do not forget to visit us at: www.crydom.com

Summary of content (5 pages)

PAGE 1
Control Relays Datasheet PCV Series • Proportional controller • Ratings from 15A to 90A @ 240 VAC • 2-7 V DC or 2-10 V DC analog input range • For use with resistive loads only PRODUCT SELECTION Description 15 A 2-7 VDC Control 2-10 VDC Control 7PCV2415 10PCV2415 25 A 7PCV2425 10PCV2425 50 A 75 A 90 A 10PCV2450 10PCV2475 10PCV2490 OUTPUT SPECIFICATIONS (1) Description Operating Voltage (47-63Hz) [Vrms] Transient Overvoltage [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mArms] Minim
PAGE 2
Control Relays Datasheet MECHANICAL SPECIFICATIONS Tolerances: ±0.02 in / 0.5 mm All dimensions are in inches (millimeters) MOUNTING HOLE/SLOT .19 ±0.10 DIA (4.9 ±0.25) 0.45 [11.4] 1.88 [47.8] BASE PLATE .125 (3.2) .8-32 TERMINAL (2 PLACES) 1.10 [27.9] 2.31 [58.7] 1.71 [43.3] 1.00 [25.4] 6-32 TERMINAL (2 PLACES) 1.80 [45.7] WIRING DIAGRAM Do not forget to visit us at: www.crydom.com Copyright © 2016 Crydom Inc. Specifications subject to change without notice. .79 [19.9] .91 [23.
PAGE 3
Control Relays Datasheet THERMAL DERATE INFORMATION TYPICAL APPLICATIONS • Industrial temperature controllers • Light dimming • Vibratory feeders • Resistive heating elements • Rectified DC motors • Conveyor speed control UNSUITABLE APPLICATIONS The PCV is not suitable for some load applications Including, but not limited to the following: • AC motor control • Three Phase motors • Transformers requiring pure sine wave input • Zero crossing applications Please contact Crydom’s application Engineering depa
PAGE 4
Control Relays Datasheet DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / 危险 HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH. • Disconnect all power before installing or working with this equipment. • Verify all connections and replace all covers before turning on power. Failure to follow these instructions will result in death or serious injury. RIESGO DE DESCARGA ELECTRICA O EXPLOSION. • Desconectar todos los suministros de energia a este equipo antes de trabajar con este equipo.
PAGE 5
Control Relays Datasheet ANNEX - ENVIROMENTAL INFORMATION The environmental information disclosed in this annex including the EIP Pollution logo are in compliance with People’s Republic of China Electronic Industry Standard SJ/T11364 – 2006, Marking for Control of Pollution Caused by Electronic Information Products.