Datasheet

ManualsBrandsSensata Crydom ManualsRelaysSolid State Relay Single Phase Series 1, SPST-NO, 25A, 140V, Screw Terminal

Series 1 120 VAC

• Ratings from 10A to 40A @ 24-140 VAC

• SCR output for heavy industrial loads

• Zero voltage or instantaneous turn-on outputs

• UL/CSA/VDE Approved, CE Compliant to EN60950-1

• Improved SEMS screw and washer

• Redesigned housing with anti-rotation barriers

For Generation 3 datasheet click here

• AC or DC control

• Direct bond copper substrate

• EMC compliant to Level 3

• Direct power lead frame

• Epoxy free design

PRODUCT SELECTION

Control Voltage 10A 25A 40A

3-32 VDC D1210 D1225 D1240

90-280 VAC A1210 A1225 A1240

18-36 VAC A1210E A1225E A1240E

AVAILABLE OPTIONS

Control Voltage

A: 90-280 VAC

D: 3-32 VDC

AxxxxE: 18-36 VAC

Rated Load Current

10: 10 Amps

25: 25 Amps

40: 40 Amps

Operating

Voltage

12: 24-140 VAC

Overvoltage Protection

Blank: Not Included

P: Included

Input Status LED

Blank: Not Included

G: Included

Termination

Blank: Screw

F: Quick Connect

(Up to 50 Amps only)

K: Hex standoffs

EA P G

Thermal Pad

Blank: Not Included

H: Included

K H

Snubber

Blank: Not Included

S: Included

Switching Type

Blank: Zero Voltage Turn-On

-10: Instantaneous Turn-On

-10

(3)

(1)

(2)

(4)

OUTPUT SPECIFICATIONS

(5)

Description 10A 25A 40A

Operating Voltage (47-440Hz) [Vrms] (6) 24-140 24-140 24-140

Transient Overvoltage [Vpk] 600 600 600

Maximum Off-State Leakage Current @ Rated Voltage [mArms]

(7) 1 1 1

Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] 500 500 500

Maximum Load Current [Arms]

(2)(8) 10 25 40

Minimum Load Current [mArms] 150 150 150

Maximum 1 Cycle Surge Current (50/60Hz) [Apk] 115/120 239/250 597/625

Maximum On-State Voltage Drop @ Rated Current [Vrms] 1.15 1.15 1.15

Thermal Resistance Junction to Case (Rjc) [°C/W] 1.03 0.8 0.5

Maximum 1/2 Cycle I² t for Fusing (50/60Hz) [A² sec] 66/60 285/259 1770/1629

Minimum Power Factor (at Maximum Load)

(3) 0.5 0.5 0.5

INPUT SPECIFICATIONS

(5)

Description D12xx A12xx A12xxE

Control Voltage Range 3-32 VDC 90-280 Vrms 18-36 Vrms

Maximum Reverse Voltage -32 VDC - -

Minimum Turn-On Voltage 3.0 VDC (9) 90 Vrms 18 Vrms

Must Turn-Off Voltage 1.0 VDC 10 Vrms 4 Vrms

Minimum Input Current [mA] 7 5 16

Maximum Input Current [mA]

10 20

Nominal Input Impedance [Ohms] Current Regulated

Maximum Turn-On Time [msec] 1/2 Cycle (10) 20 20

Maximum Turn-Off Time [msec] 1/2 Cycle 30 30

Required for valid part number

For options only and not required for valid part number

Not all part number combinations are available.

Contact Crydom Technical support for information on

the availability of a specific part number.

Do not forget to visit us at: www.crydom.com

Datasheet

Panel Mount

Summary of content (7 pages)

PAGE 1
Panel Mount Datasheet Series 1 120 VAC • Ratings from 10A to 40A @ 24-140 VAC • SCR output for heavy industrial loads • Zero voltage or instantaneous turn-on outputs • UL/CSA/VDE Approved, CE Compliant to EN60950-1 • Improved SEMS screw and washer • Redesigned housing with anti-rotation barriers • AC or DC control • Direct bond copper substrate • EMC compliant to Level 3 • Direct power lead frame • Epoxy free design For Generation 3 datasheet click here PRODUCT SELECTION Control Voltage 3-32 VDC 90-280 V
PAGE 2
Panel Mount Datasheet GENERAL SPECIFICATIONS (5) Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 VDC) 4000 Vrms 109 Ohm 8 pF -40 to 80 °C -40 to 125 °C 2.6 oz (74.9g) UL 94 V-0 Aluminum 13-15 /1.5-1.7 18-20 / 2.0-2.2 18-20 / 2.0-2.2 w/”K” option 8-10 / 0.9-1.
PAGE 3
Panel Mount Datasheet MECHANICAL SPECIFICATIONS (5) Tolerances: ±0.02 in / 0.5 mm All dimensions are in: inches [millimeters] Screw Termination 1.1 [27.9] 0.49 [12.4] 1 1.88 [47.6] OUTPUT INPUT 1.1 [27.9] 0.49 [12.4] 0.89 [22.6] Mounting Hole/Slot 0.19 [4.9] DIA. 1 2 2.25 [57.3] 1.7 [43.2] S O L I D S TAT E R E L AY 4 Hex Standoff Termination (“K” Option) (2) 1.88 [47.6] OUTPUT INPUT 1.58 [40.2] 0.49 [12.4] 1 1.88 [47.6] OUTPUT Faston Terminal(16) 0.25 x 0.032 INPUT 1.40 [35.6] 1.
PAGE 4
Panel Mount Datasheet SURGE CURRENT INFORMATION 25 A 250 100 200 Surge Current (Amp) Surge Current (Amp) 10 A 120 80 60 40 20 0 0.01 0.1 1 Surge Duration (Secs) 150 100 50 0 0.01 10 0.1 1 Surge Duration (Secs) 10 40 A Surge Current (Amp) 600 500 400 300 200 100 0 0.01 0.1 1 Surge Duration (Secs) 10 Non repetitive peak surge current at Tj initial 40ºC. THERMAL DERATE INFORMATION 10 A 3ºC/W 5ºC/W 25 A 1.
PAGE 5
Panel Mount Datasheet AGENCY APPROVALS EN60950 : Meets the requirements of sections1.5: 1,7: 2.9: 2.10.5.3: 4.2: 4.5: 4.7: Designed in accordance with the requirements of IEC 62314 IEC 61000-4-2 : Electrostatic Discharge – Level 3 IEC 61000-4-4 : Electrically Fast Transients – Level 3 IEC 61000-4-5 : Electrical Surges – Level 3 IEC 60068-2-6 : Vibration 0.33mm and 0.
PAGE 6
Panel Mount Datasheet DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / 危险 HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH. • Disconnect all power before installing or working with this equipment. • Verify all connections and replace all covers before turning on power. Failure to follow these instructions will result in death or serious injury. RIESGO DE DESCARGA ELECTRICA O EXPLOSION. • Desconectar todos los suministros de energia a este equipo antes de trabajar con este equipo.
PAGE 7
Panel Mount Datasheet ANNEX - ENVIROMENTAL INFORMATION The environmental information disclosed in this annex including the EIP Pollution logo are in compliance with People’s Republic of China Electronic Industry Standard SJ/T11364 – 2006, Marking for Control of Pollution Caused by Electronic Information Products.