Datasheet

Series 1-DC
• MOSFET output
• Ratings from 60A to 100A @ 100 VDC
• DC control
• Relays are easily paralleled for higher-current applications
PRODUCT SELECTION
Control Voltage 60A 80A 100A
3.5-32 VDC D1D60 D1D80 D1D100
OUTPUT SPECIFICATIONS (1)
Description D1D60 D1D80 D1D100
Operating Voltage [Vdc] 0-100 VDC 0-100 VDC 0-100 VDC
Maximum Off-State Leakage Current @ Rated Voltage [mA] 0.1 0.2 0.3
Maximum On-State Resistance @ Rated Current [RDS-ON][Ohms] 0.010 0.008 0.005
Maximum Load Current (3) [Adc] 60 80 100
Minimum Load Current [mA] 5 5 5
Maximum Surge Current [Adc] (10ms) 180 220 330
Maximum On-State Voltage Drop @ Rated Current [Vdc] 0.6 0.7 0.5
Thermal Resistance Junction to Case (Rjc) [°C/W] 0.6 0.47 0.32
INPUT SPECIFICATIONS (1)
Description DC Control
Control Voltage Range 3.5-32 VDC
Minimum Turn-On Voltage 3.5 VDC
Minimum Turn-Off Voltage 1.0 VDC
Maximum Input Current 1.6 mA (5 VDC), 28 mA (32 VDC)
Nominal Input Impedance See Note 4
Maximum Turn-On Time [μsec] 300
Maximum Turn-Off Time [msec] 1.0
GENERAL SPECIFICATIONS
Description Parameters
Dielectric Strength, Input/Output/Base (50/60Hz) 2500 Vrms
Minimum Insulation Resistance (@ 500 V DC)
10
9
Ohm
Maximum Capacitance, Input/Output 50 pF
Ambient Operating Temperature Range -30 to 80°C
Ambient Storage Temperature Range -40 to 125 °C
Weight (typical) 3.0 oz (86.5g)
Encapsulation Thermally conductive Epoxy
Terminals Screws and Saddle Clamps Furnished, Unmounted
Recommended Terminal Screw Torque Range: 6-32 Screws - 10 in lbs. 8-32 and 10-32 Screws -20 in. lbs. (Screws dry without grase)
GENERAL NOTES
1) All parameters at 25°C and per section unless oth erwise specified.
2) Dielectric strength and insulation resistance are measured between input and output
3) Heat sinking required, see derating curves.
4) Input circuitry version incorporates active current limiter.