Datasheet

ManualsBrandsSensata Crydom ManualsRelaysSolid State Relay Single Phase 1-DC, SPST-NO, 40A, 100V, Screw Terminal

1-DCL Series

• Ratings from 7 A to 40 A @ 200 VDC and

from 7 A to 10 A @ 500VDC

• Mosfet Output

• UL Approved, CE Compliant to EN60950-1

• Improved SEMS screw and washer

• Redesigned housing with anti-rotation barriers

For Generation 3 datasheet click here

• DC control

• EMC Compliant to Level 3

• Epoxy Free Design

PRODUCT SELECTION

Load Voltage 7 A 10 A 12 A 20 A 40 A

100 VDC D1D07L D1D12L D1D20L D1D40L

200 VDC D2D07L D2D12L D2D40L

400 VDC D4D07L D4D12L

500 VDC D5D07L D5D10L

AVAILABLE OPTIONS

Not all part number combinations are available.

Contact Crydom Technical Support for information on

the availability of a specific part number.

Required for valid part number

For options only and not required for valid part number

Series

Operating Voltage

1D: 1-100 VDC

2D: 1-200 VDC

4D: 1-400 VDC

5D: 1-500 VDC

Rated Load Current

07: 7 Amps

10: 10 Amps (500 VDC only)

12: 12 Amps (not for 500 VDC)

20: 20 Amps (100 VDC only)

40: 40 Amps (100 & 200 VDC only)

071D

Termination

Blank: Screws & clamps

K: Installed standoffs with

screws for PC Board

mounting (1)

INPUT SPECIFICATIONS

(2)

Description DC Control

Control Voltage Range 3.5-32 VDC

Maximum Reverse Voltage -32 VDC

Minimum Turn-On Voltage (6) 3.5 VDC

Must Turn-Off Voltage 1 VDC

Minimum Input Current (for on-state) 10 mA

Maximum Input Current 15 mA

Nominal Input Impedance Current Regulated

Maximum Turn-On Time [µsec] 100

Maximum Turn-Off Time [µsec] 100

OUTPUT SPECIFICATIONS

(2)

Description 7 A7 A12 A40 A12 A

Recommended Operating Voltage [Vdc] 1-72 1-72 1-150 1-300 1-385

Absolute Maximum Rating [Vdc] 100 100 200 400 500

Maximum Off-State Leakage Current @ Rated Voltage [mA] 0.2 0.3 0.3 0.3 0.2

Maximum Load Current [Adc]

(3) 12 40 12 7 7

Minimum Load Current [mA]

(4) 1 1 1 1 1

Maximum Surge Current (10msec) [Adc] 28 106 31 18 19

Maximum On-State Voltage Drop @ Rated Current [Vdc] 0.9 1 0.7 2.3 3.5

Maximum On-State Resistance [RDS-ON] [Ohms] 0.072 0.025 0.062 0.33 0.5

Thermal Resistance Junction to Case (Rjc) [°C/W] 2 0.68 0.71 0.56 0.6

Minimum Heat Sink for Rated Current @ 40°C [°C/W] 3 1 3 2 1

12 A40 A7 A20 A7 A

1-72 1-72 1-150 1-150 1-300

100 100 200 200 400

0.1 0.3 0.1 0.3 0.3

7 20 7 40 12

1 1 1 1 1

23 42 22 106 36

0.5 0.8 1.5 0.8 2.6

0.07 0.039 0.21 0.021 0.22

2 1.71 1.24 0.22 0.39

5 2 3 0.7 1

10 A

1-385

500

0.3

3.3

0.33

0.43

0.7

Maximum Pulse Width Modulation Frequency [Hz] (5) 4000 2500 2000 1200 1100

5000 3500 3500 950 900

900

Datasheet

Panel Mount

Do not forget to visit us at: www.crydom.com

Summary of content (8 pages)

PAGE 1
Panel Mount Datasheet 1-DCL Series • Ratings from 7 A to 40 A @ 200 VDC and from 7 A to 10 A @ 500VDC • Mosfet Output • UL Approved, CE Compliant to EN60950-1 • Improved SEMS screw and washer • Redesigned housing with anti-rotation barriers • DC control • EMC Compliant to Level 3 • Epoxy Free Design For Generation 3 datasheet click here PRODUCT SELECTION Load Voltage 7A 100 VDC 200 VDC 400 VDC 500 VDC AVAILABLE OPTIONS Series D * 10 A D1D07L D2D07L D4D07L D5D07L 20 A 40 A D1D20L D1D40L D2D40L
PAGE 2
Panel Mount Datasheet GENERAL SPECIFICATIONS (2) Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 VDC) Maximum Capacitance, Input/Output Ambient Operating Temperature Range (7) Ambient Storage Temperature Range Weight (typical) Housing Material Baseplate Material Input Terminal Screw Torque Range (in-lb/Nm) Load Terminal Screw Torque Range (in-lb/Nm) SSR Mounting Screw Torque Range (in-lb/Nm) Input/Load Terminal Screw Torque Range (in-lb/Nm) (1)
PAGE 3
Panel Mount Datasheet MECHANICAL SPECIFICATIONS (2) Tolerances: ±0.02 in / 0.5 mm All dimensions are in: inches [millimeters] Screw Termination 1.1 [27.9] 0.49 [12.4] 1 1.88 [47.6] OUTPUT INPUT 1.1 [27.9] 0.49 [12.4] 0.89 [22.6] Mounting Hole/Slot 0.19 [4.9] DIA. +2 1 2.25 [57.3] 1.7 [43.2] S O L I D S TAT E R E L AY 4 Hex Standoff Termination (“K” Option) (1) 1.88 [47.6] +2 INPUT 1.0 [25.4] 1.0 [25.4] 1.75 [44.5] 1.75 [44.5] 2.25 [57.3] 1.7 [43.
PAGE 4
Panel Mount Datasheet SURGE CURRENT INFORMATION Single Pulse (i) Duty Factor (10%) (ii) Duty Factor (50%) (ii) Duty Factor (20%) (ii) D2D07L D2D12L 70 40 Surge Current (Amp) Surge Current (Amp) 50 30 20 10 0 0.1 1 10 100 Surge Duration (msec) 60 50 40 30 20 10 0 1000 Surge Current (Amp) Surge Current (Amp) 1 10 Surge Duration (msec) 100 1000 50 40 30 20 10 0 0.1 1 D4D07L D2D40L 240 220 200 180 160 140 120 100 80 60 40 20 0 0.1 10 100 Surge Duration (msec) 1000 0.
PAGE 5
Panel Mount Datasheet THERMAL DERATE INFORMATION (iii) SSR metal base plate acting as heat sink, it must be exposed to free ambient air.
PAGE 6
Panel Mount Datasheet AGENCY APPROVALS Agency Approvals EN60950-1: Meets the requirements of sections1.5: 1,7: 2.9: 2.10.5.3: 4.2: 4.5: 4.7: IEC 61000-4-2 Electrostatic Discharge Level 3 IEC 61000-4-4 Electrically Fast Transients Level 3 IEC 61000-4-5 Electrical Surges Level 3 E116950 ACCESORIES Recommended Accessories New Accessories! Protective Cover & Hardware Kits Protective Cover Part number: KS101 Clear plastic cover compatible with all new S1 designs.
PAGE 7
Panel Mount Datasheet DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / 危险 HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH. • Disconnect all power before installing or working with this equipment. • Verify all connections and replace all covers before turning on power. Failure to follow these instructions will result in death or serious injury. RIESGO DE DESCARGA ELECTRICA O EXPLOSION. • Desconectar todos los suministros de energia a este equipo antes de trabajar con este equipo.
PAGE 8
Panel Mount Datasheet ANNEX - ENVIROMENTAL INFORMATION The environmental information disclosed in this annex including the EIP Pollution logo are in compliance with People’s Republic of China Electronic Industry Standard SJ/T11364 – 2006, Marking for Control of Pollution Caused by Electronic Information Products.