User Manual

ManualsBrandsSensei ManualsLens Accessories52mm Screw-on Tulip Lens Hood

Introduction

Thank you for choosing Sensei™.

The Sensei Screw-On Lens Hood mounts securely to your

camera lens to prevent stray light from entering, thus

eliminating glare and lens flare. The lens hood also helps to

minimize impact damage to the lens.

Instructions

1. Start with the camera facing away from you, and the TOP

label on the lens hood facing up.

2. Match up the lens hood with the thread on the inside of the

camera lens, and rotate the hood clockwise two full turns.

3. Keeping the TOP label aligned with the top of the lens, rotate

the locking collar on the lens hood clockwise until the collar

applies pressure to the front of the lens, securing the lens hood

in its correct position.

Note:

Improper installation of the lens hood may cause vignetting –

verify that the word “TOP” is facing upward on the hood and

the longer “petals” are oriented in top and bottom positions.

One-Year Limited Warranty

This SENSEI product is warranted to the original purchaser to be free

from defects in materials and workmanship under normal consumer

use for a period of one (1) year from the original purchase date or

thirty (30) days after replacement, whichever occurs later. The

warranty provider’s responsibility with respect to this limited

warranty shall be limited solely to repair or replacement, at the

provider’s discretion, of any product that fails during normal use of

this product in its intended manner and in its intended environment.

Inoperability of the product or part(s) shall be determined by the

warranty provider. If the product has been discontinued, the

warranty provider reserves the right to replace it with a model of

equivalent quality and function.

This warranty does not cover damage or defect caused by misuse,

neglect, accident, alteration, abuse, improper installation or mainte-

nance. EXCEPT AS PROVIDED HEREIN, THE WARRANTY

PROVIDER MAKES NEITHER ANY EXPRESS WARRANTIES NOR

ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO

ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS

FOR A PARTICULAR PURPOSE. This warranty provides you with

specific legal rights, and you may also have additional rights that

vary from state to state.

To obtain warranty coverage, contact the Sensei Customer Service

Department to obtain a return merchandise authorization (“RMA”)

number, and return the defective product to Sensei along with the

RMA number and proof of purchase. Shipment of the defective

product is at the purchaser’s own risk and expense.

For more information or to arrange service, visit

www.madebysensei.com or call Customer Service at 212-594-2353.

Product warranty provided by the Gradus Group.

www.gradusgroup.com

SENSEI is a registered trademark of the Gradus Group.

2. 3.