User Manual

Thank you for choosing Sensei.
Congratulations on the purchase of your Sensei
Cut-to-Fit LCD Screen Protector Kit. This cut-to-fit
screen protector is designed to protect your
device’s LCD screen from scratches, dust, and
smears. It’s easy to apply and remove, it adheres to
the LCD screen without leaving behind any sticky
residue, and the paper backing includes printed
grid lines to help you custom-fit the screen
protector to the exact size you need.
Please read these instructions carefully before
applying your Sensei Cut-to-Fit LCD Screen
Protector.
Box Contents
• Six (6) screen protectors
• Three (3) wet wipes
• Three (3) dry wipes
• Applicator card
Instructions
Note: Before applying your Cut-to-Size LCD
Screen Protector, you must determine the size of
your camera’s LCD screen.
1. Measure the height
and width your
device’s LCD screen
in millimeters.
2. Using a pair of
scissors or a razor and
a straight edge, trim
the screen protector
along the guidelines
that correspond to
your camera’s LCD
size.
3. Remove all films or
other intervening
substances from your
camera’s LCD.
4. Clean the LCD with
the included wet wipe,
and then wipe it dry
with the dry wipe. Be
sure to remove all dust
and fingerprints.
5. Partially peel off
the backing from the
screen protector. Be
careful not to get any
fingerprints on the
exposed side of the
screen protector.
6. Make sure your
camera is on a stable
surface, and align the
screen protector with
the camera’s LCD.
Tip: Turning on the
LCD will make it easier
to see the edges
when aligning the screen protector.
7. Hold the backing of
the screen protector
up while gently
pushing down on the
screen protector with
the included
applicator card. As
you push the
applicator card along
the camera’s LCD to apply the screen protector,
the backing will gradually peel off.
8. Use the applicator
card to smooth out
any remaining air
bubbles by pushing
them to the edge of
the screen protector.
One-Year Limited Warranty
This SENSEI product is warranted to the original purchaser to be
free from defects in materials and workmanship under normal
consumer use for a period of one (1) year from the original
purchase date or thirty (30) days after replacement, whichever
occurs later. The warranty provider’s responsibility with respect
to this limited warranty shall be limited solely to repair or
replacement, at the provider’s discretion, of any product that fails
during normal use of this product in its intended manner and in
its intended environment. Inoperability of the product or part(s)
shall be determined by the warranty provider. If the product has
been discontinued, the warranty provider reserves the right to
replace it with a model of equivalent quality and function.
This warranty does not cover damage or defect caused by
misuse, neglect, accident, alteration, abuse, improper installation
or maintenance. EXCEPT AS PROVIDED HEREIN, THE
WARRANTY PROVIDER MAKES NEITHER ANY EXPRESS
WARRANTIES NOR ANY IMPLIED WARRANTIES, INCLUDING
BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE. This warranty provides you with specific legal rights,
and you may also have additional rights that vary from state to
state.
To obtain warranty coverage, contact the Sensei Customer
Service Department to obtain a return merchandise authorization
(“RMA”) number, and return the defective product to Sensei
along with the RMA number and proof of purchase. Shipment of
the defective product is at the purchaser’s own risk and expense.
For more information or to arrange service, visit
www.madebysensei.com or call Customer Service at
212-594-2353.
Product warranty provided by the Gradus Group.
www.gradusgroup.com
SENSEI is a registered trademark of the Gradus Group.
© 2016 Gradus Group LLC. All Rights Reserved.
Cut-to-Fit LCD
Screen Protector Kit
SPS-R
USER MANUAL