User manual

15
4 Put a bowl with a capacity of at least 1.5 litres
under the spout to collect the water.
5 Press the 1-cup button q and the 2-cup
button qq at the same time for 3 seconds
until you hear a beep to start the ushing
cycle.
6 Remove the used pod and clean the pod
holder after the ushing cycle to prevent the
sieve in the centre from getting clogged.
7 Repeat steps 1 to 6 once more to ensure a
clean machine.
8 After the descaling cycle and the ushing
cycles, the CALC light goes out and the
machine switches off automatically.
7.2 Flushing after descaling
1 Rinse the water reservoir under the tap and
then ll it to the top with fresh tap water.
D
Notes:
Do not rell the water reservoir with used
hot water or the used descaling mixture.
2 Tilt the water reservoir and place the bottom
back onto the machine (1). Then press the top
of the water reservoir towards the machine
(2).
3 Place the 1-cup pod holder q with a used
coffee pod in it in the coffee machine. Close
the lid and make sure it is properly locked.
ENGLISH