User manual

From now on, your SENSEO

machine brews one

or two cups with this amount of coffee when you

select the personal coffee memory symbol with

the selection button.

Note:

If you want to change the set amount of coffee,

simply perform steps 1-4 again.

6.2 Flushing the machine after

a day of non-use

If you have not used the coffee machine for one

day, ush it to make sure that the boiler is lled

with fresh water.

To ush the machine, brew two cups of hot

water in the following way:

1 Fill the water reservoir with cold tap water

beyond the MIN level (1). Put the lid on it (2)

and put it the water reservoir back onto the

machine.

2 Put the 1-cup pod holder q or the 2-cup pod

holder qq in the machine without pods.

6.1 Personal coffee memory

You can program the machine to brew the amount of

coffee you prefer (up to 145ml). Simply experiment

and nd out what you like best. We advise you to

brew at least 60ml for optimal taste and temperature.

While programming, you can only use the 1-cup

button. When you have completed the programming

process, you will be able to brew one or two cups

with the programmed amount of coffee.

Note:

It is not possible to program your personal coffee

memory while the machine is heating up. Wait

until the on/off button lights up continuously.

1 Place 1 coffee pod in the 1-cup pod holder

and place 1 cup under the spout openings.

2 To enter the programming mode, rst select

the personal coffee memory symbol (star

symbol) with the selection button (1). Keep the

selection button pressed for 2 seconds until the

star symbol starts ashing (2) and you hear a

beep. Then release the selection button.

3 Press the 1-cup button to make the coffee

ow into the cup (1). When the cup contains

the amount of coffee you prefer, press the

1-cup button again (2). Your preferred amount

of coffee has been set.