User Manual

2
FCC Statement
The OEM100 and OEM1000 equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
FCC Caution: Any changes or modifications not expressly approved by Sensicast could void the user’s
authority to operate this equipment.
FCC RF Radiation Exposure Statement: To comply with FCC’s RF exposure limits for general
population/uncontrolled exposure, the antenna(s) used for this transmitter must be installed to provide a
separation distance of 20 cm from all persons and must not be co-located or operated in conjunction with any
other antenna or transmitter.
FCC Labeling
The module is labeled with its own FCC ID number (RNB-OEM100 or RNB-OEM1000). If this number is
not visible when the module is installed inside another device, then the outside of the device into which the
module is installed must also display a label with the following wording: “Contains FCC ID:RNB-OEM100” or
“Contains FCC ID:RNB-OEM1000”
OEM Responsibility to the FCC Rules and Regulations
The OEM100 and OEM1000 modules have been certified per FCC part 15 rules for integration into products
without further testing or certification. To fulfill the FCC certification requirements the OEM using the
OEM100 or OEM1000 module must ensure that the information provided on the OEM100 or OEM1000
Lavel is placed on the outside of the final product. The OEM100 or OEM1000 module is labeled with its own
FCC ID number (RNB-OEM100 or RNB-OEM1000). If this FCC ID number is not visible when the module
is installed inside another device, then the outside of the device into which the module is installed must also
display a label with the following wording: “Contains FCC ID:RNB-OEM100” or “Contains FCC ID:RNB-
OEM1000”.
The OEM of the OEM100 or OEM1000 Module must only use the approved antenna, which has been
certified with this module.
The OEM of the OEM100 or OEM1000 Module must test their final product configuration to comply with
Unintentional Radiator Limits before declaring FCC compliance per part 15 of the FCC rules.
Industry Canada Statement per Section 4.0 of RSP-100
The term IC: before the certification / registration number only signifies that Industry Canada technical
specifications were met.
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired
operation.
Section 2.6 of RSS-102
This mobile transmitter with its antenna complies with Industry Canada RF Exposure Limits for General
Population / Uncontrolled Exposure.