Installation Guide

Rigid 11.81" 0.8W 12 Diode Strip Light
Installation
Sensio America
877-501-5337
www.sensioamerica.com
• Ensure that the power is disconnected prior to cleaning.
• To keep the finish of this product, wipe over with soft cloth
periodically.
• Do not use harsh chemical solvents, it may discolor or
damage the finish.
Maintenance & Care
Support
12
Connect driver to power.
Connect to driver.
10
Staple wire in place along inside front
edge of cabinet (optional).
11
Feed driver lead wire through hole up
along inside front corner of cabinet.
8
Snap strips into clips, driver lead on
side of drilled hole.
7
Feed driver lead to LED driver.
9
Plug strips together.
5
Attach driver lead into strip.
6
(FRONT OF CABINET)
Drill 5/16" hole in bottom front corner.
1
Determine placement (front, center, or back), use
pencil to draw line. Measure line drawn.
2
Determine how many strips needed and
mark off where each strip will be placed.
3
Install two clips for each strip with
screws provided.
4