Instructions / Assembly

Installation
Instructions
IMPORTANT: Please read these instructions before starting installation and retain for future reference.
Components: Tools Required:
Driver Installation
Instructions
Screws Screwdriver
24V 20W Driver
with 12 Port ML
Block
Product #: SA40655
Important Safety Information Safety Instructions
Sensio America
877-501-5337
www.sensioamerica.com
Maintenance & Care
Support
• Ensure that the power is disconnected prior to cleaning.
• To keep the finish of this product, wipe over with soft cloth
periodically.
• Do not use harsh chemical solvents, it may discolor or
damage the finish.
Determine mounting location
Use supplied screws to mount driver
in place
Plug ML connector leads from lights
into ML Block
Plug Driver into wall outlet
1
3
4
Installation
2
2
Please read these instructions carefully before attempting to install
this product. It is advisable to keep these instructions in a safe place
for further reference. These products must not be modified; if any
modifications are made, it may invalidate the warranty and may
render the product unsafe. This product is for indoor use only. Keep
out of moisture and use only in dry rooms.
CAUTION : To reduce the risk of fire, electric shock, or injury to
persons:
a) Use only insulated staples or plastic ties to secure cords;
b) Route and secure cords so that they will not be pinched or
damaged;
c) Not intended for recessed installation in ceilings, or soffits.
The National Electrical Code (NEC) does not permit cords to be
concealed where damage to insulation may go unnoticed. To prevent
fire danger, do not run cord behind walls, ceilings, soffits, or cabinets
where it may be inaccessible for examination. Cords should be
visually examined periodically and immediately replaced when any
damage is noted.
Warning: The installation of this power driver should be
performed by qualified personnel.
• Failure to mount and wire the driver and the fixture in
conformance with applicable codes, standards, and
regulations for the intended working environment may
cause serious personal injury, death and/or property
damage.
• During installation, power to the driver and the fixture
must be disconnected at all times.
• This driver can only be used to supply the low voltage LED
lamps (DC24V).
• Protection against electric shock should be ensured during
the installation.
• The driver is short circuit protected at the secondary side.
• The lighting loads of the driver must neither exceed nor go
below the 1-20W range.