User's Manual

T11012860 User Manual

2. Physical Appearance

2.1. User Interface

The user interface consists of the following:

1. Six LEDs (2 sets of red, green, blue)

2. Two buttons(Start/Status)

2.1.1. LEDs

The LEDs are intended to allow quick and easy-to-read status to be conveyed to the

end user. The user can immediately know the status of the unit during startup and

operation.

2.1.1.1. System Startup Sequence

During startup, the Blue LED will blink rapidly.

Once it has completed its startup tests, the LED will indicate the

following:

Red

Hardware test failure, solid

Low battery, blinking

Green

Attempt to get on network, blinking

Blue

Hardware test complete, no blinking

2.1.2. Buttons

There are two buttons on the device:

1. Start/Stop – a configurable press delay is added, usually configured to be

held for three second before it starts.

2. Status– a configurable press delay is added usually configured to be held for

three seconds before it conducts a status check.