Installation Instructions

www.sensolus.com | [e-mail]
Hold a magnet for about 5
seconds on top of the logo on
the asset tracker.
You will rst see a red LED. Do
not remove the magnet yet.
When the green LED is blinking
you can remove the magnet.
Your tracker is ready for use.
Troubleshoong
Acvaon of the trackers is preferably done with clear skies, and not inside (e.g. factory or warehouse).
Trackers are not acvated when delivered to your premises.
Their subscripon in the plaorm will start within six month of purchase.
Tracker acvaon
1. Put the magnet on the tracker for less than 5 seconds
2. The possible LED feedback opons are:
Red LED:
Tracker is not acvated
Green LED:
Tracker is acvated and working
properly
No LED:
tracker is not funconing
(probably dead baery ->
contact support)
Red LED is blinking:
Tracker is busy
Force new conguraon download on the tracker
Hold a magnet for about 5
seconds on top of the logo on
the asset tracker.
You will see a green LED.
You will see a red and green
LED.
Now remove the Magnet
Green LED is blinking for
minimum 30 seconds.
Your tracker is checking for new
conguraons
You see a red LED:
No new conguraon received
You see a green LED: New
conguraon seng received
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operaon.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instrucons, may cause
harmful interference to radio communicaons. However, there is no guarantee that interference will not occur in a parcular instal-
laon. If this equipment does cause harmful interference to radio or television recepon, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
This transmier must not be co-located or operang in conjuncon with any other antenna or transmier.
Radiaon Exposure Statement:
This equipment complies with FCC radiaon exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.