User Manual

4
The alarms are fitted with two test functions:
1. The test button on the face of the alarm can be used to test the alarm if
required.
2. The alarm is also fitted with a software-based test which can be
scheduled for a particular date and time or performed in real time via
the portal.
The alarms are also fitted with several additional functions to ensure
safety and compliance, including:
• Early low battery detection – designed to pre-empt a low battery alarm so it
can be replaced prior to low battery beeping.
• Tamper detection – to ensure the alarms are always closed and operating
correctly.
• RF disconnect warning – should an alarm become disconnected from the
network a notification will be sent via the portal.
• 230V power outage – if power is lost to the alarm or hub a notification will
be sent via the portal.
Disclaimers
All electrical installations must be carried out by a qualified electrician, in accordance
with local regulations and Australian Standards.
It remains the duty of the installer to ensure that:
• All hardware is undamaged and in proper operating order,
• The correct number of alarms are being installed in compliant locations as per
the local requirements.
This product must only be used for the purpose described in these instructions and
must be installed by a licensed electrician in accordance with the Building Code
Australia (BCA) and local and state wiring rules and regulations.