User's Manual

Step 6. The blue light on the far right of the Hub should still be flashing. After

approximately three to five minutes after scanning the QR code, the light will turn

solid blue.

Step 7. Wait a further 30 seconds for the app to show a green “Connected”

against the Hub. If the app does not automatically refresh after 30 seconds, tap

the “Refresh” button. The Hub must display as “Connected” on the app before

proceeding.

Only after completing Steps 1-7 above, proceed with Step 8 below to setup the

required number of SENSOR 217E-02 Photoelectric Smoke Alarms.

Quick Start Guide for the SENSOR Alarms (217E-02 & 217E-

03)

Connection

TO PAIR ANY SENSOR ALARM TO THE SENSOR NETWORK YOU MUST HAVE

INSTALLED THE SENSOR Hub (217E-C001)

first.

Alarm Pairing Process

Step 8. Remove all packaging from the alarm, including the battery isolation tab

in the clip of the alarm. Close the alarm.

Step 9. Re-open the alarm to ensure that the tamper alert sounds. Close the alarm

again until it clicks.

DO NOT SCAN THE QR CODE ON THE ALARM UNTIL YOU HAVE PUT THE

ALARM INTO PAIRING MODE

Step 10. Double-tap the “Test” button on the alarm to put the alarm in pairing

mode. Pairing mode is indicated by an orange flashing indicator light which will

last for two minutes. Note: This orange light must be flashing when performing step

11. If two minutes elapse and the orange indicator light is no longer flashing,

repeat step 10.