User's Manual

Step 11. Open the alarm and scan the QR code on the inside of the alarm using

the app. The alarm will beep to indicate that it has been successfully paired. The

API will send the “Add” command to the Hub, which will then link the alarm to the

Hub. This process takes approximately ten seconds.

Step 12. Repeat the above steps 8 to 11 to set up additional alarm(s) as required.

Now Install the Hub on the wall and Alarms on the ceiling.

Installation of HUB

Step 13. Identify a suitable location for the installation of the Hub according to the

following guide:

a. Choose a central location within the property near a low-use power outlet,

such as behind the fridge or above a roller door motor.

b. Avoid areas that are frequently used or subject to high traffic.

c. Ensure there is at least 15cm between the Hub installation point and the

closest right-hand wall, to allow adequate room to access the release

button

Step 14. Identify the electrical circuit that will power the Hub and turn the circuit

off prior to installation.

Step 15. Use the provided fixing screws and plugs to install the mounting plate

adjacent to the chosen power outlet as shown in Fig 1. Locate the mounting plate

from the back of the Hub. Turn the mounting plate over and identify the arrow

indicator. This arrow must point upwards when installing the mounting plate, as

shown in Fig 2.

Step 16. Establish a connection between the power lead provided and the chosen

circuit using a junction box (not provided) or alternate termination method. Ensure