User's Manual

Installation of the SENSOR Alarms

All SENSOR Alarms in the 217E series can be used to satisfy the 230 V or 10-year

lithium requirement - depending on the applicable installation legislation or other

local or state requirements.

At this point you must determine whether the alarm will operate on 230 V power

or a 10-year lithium battery. Consult all relevant legislation before deciding on the

correct course.

For a 240 V installation, see steps 20-27.

For a 10-year lithium (battery operated) installation, see steps 28–32.

THIS ALARM IS A HINGED DESIGN AND THE ALARM CANNOT BE REMOVED

FROM THE BASE PLATE FOR INSTALLATION. TAKE CARE WHEN INSTALLING

TO ENSURE THAT EXCESSIVE PRESSURE IS NOT APPLIED TO THE ALARM

WHILE IN THE OPEN POSITION.

240 V Installation

Step 20. Identify the installation or replacement location.

Step 21. Ensure that the location selected is compliant to local rules and that the

wiring is in place and free from damage or deterioration.

Step 22. Identify the electrical circuit that will power the alarm and turn the circuit

off prior to installation.