User's Manual

22
Testing Alarms (AFTER ALL PRODUCTS INSTALLED)
After installation of the SENSOR Hub and SENSOR Alarms is complete, and the
Alarms have been connected to the SENSOR network via the SENSOR app, it is
time to test the alarms.
Step 33. Use the “Full Test” button in the App to test the full connection of all
alarms to the SENSOR hub.
After pressing the test button, it’s a great time to start packing up as the testing
cycle can take up to five minutes to complete.
Each installed alarm will run through a test cycle in sequence.
If more than one alarm is installed, the alarms (after connection) will be interlinked
- when one alarm sounds, all installed alarms will sound.
Removing an Alarm
To remove an Alarm, tap the remove alarm icon in the
App and confirm. Please remove the Alarm from the
premises and dispose appropriately.
Removing a SENSOR Hub
To remove a SENSOR Hub, tap the remove hub icon in
the App and confirm. Please remove the SENSOR Hub from
the premises and dispose appropriately.
Once Testing is complete
Step 34. Add any necessary job notes.