Installation Guide

AMS-9080 CONTROLLER 8200-0914-01 REV. A
INSTALLATION GUIDE 21 of 22 *8200-0914-01*
Other declarations
WARRANTY DISCLAIMER: Sensormatic Electronics, LLC makes no representation or warranty with respect to the contents hereof and
specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. Further, Sensormatic Electronics, LLC
reserves the right to revise this publication and make changes from time to time in the content hereof without obligation of Sensormatic
Electronics, LLC to notify any person of such revision or changes.
LIMITED RIGHTS NOTICE: For units of the Department of Defense, all documentation and manuals were developed at private expense
and no part of it was developed using Government Funds. The restrictions governing the use and disclosure of technical data marked with
this legend are set forth in the definition of “limited rights” in paragraph (a) (15) of the clause of DFARS 252.227.7013. Unpublished -
rights reserved under the Copyright Laws of the United States.
TRADEMARK NOTICE: Sensormatic is a registered trademark of Sensormatic Electronics, LLC. Wiremold
®
is a registered trademark of
the Wiremold Company. Other product names mentioned herein may be trademarks or registered trademarks of Sensormatic or other
companies.
No part of this guide may be reproduced in any form without written permission from Sensormatic Electronics, LLC.
AMS-9080 Controller dimensions
Figure 9. AMS-9080 Controller top view
A
207.0 mm or 8.15 in.
Figure 10. AMS-9080 Controller side view
A
96.9 mm or 3.81 in.
B
532.5 mm or 20.96 in.