Installation Guide

AMS-9080 CONTROLLER 8200-0914-01 REV. A
INSTALLATION GUIDE 4 of 22 *8200-0914-01*
Conduit support
Seven knockouts receive exposed cables or cables in conduit. Knockouts are available for Class-2 wiring from
antennas and low voltage devices.
Parts
Table 1. Required parts
Kit
Quantity
Product code
AMS-9080 Controller
1
ZE9080
Installation Kit
1
0352-0286-02
Table 2. Installation Kit, 0352-0286-02
Part
Quantity
Product code
Clamp, conduit
10
6010-0107-01
Compatibility
The AMS-9080 Controller is compatible with the following products:
 AMS-1156 Pedestal
 Ranger antennas
 Satellite antennas
 Amorphous core receivers
 Digital Remote Alarm (DRA)
 Ultra-Link
 Local Device Manager (LDM)
 Wireless Device Manager (BIM1000) and the Wireless Device Module (BIX1000)
 Overhead people counters
Safety
Installation requirements
Intended use: Install this device only as described in this guide.
The installer or contractor must adhere to the following criteria:
 Ensure that electrical work complies with the latest national electrical code, national fire code, and all
applicable local codes and ordinances. National or local wiring codes or rules can differ between regions.
Adherence to these codes supersedes instructions in this document.
 You must coordinate all work with other trades to avoid interference.
 You must verify existing site conditions, and coordinate with the owner’s representative and appropriate
utilities, as required.
 You must obtain copies of all related plans, specifications, shop drawings, and addenda to schedule and
coordinate related work.
 You must thoroughly review the project to ensure that all work meets or exceeds the above requirements.
The installer or contractor must bring any alleged discrepancies to the attention of Sensormatic Electronics.