Operator`s manual

1-4 SpeedDome Ultra VI Operator's Manual
Entering the Dome's Password
A dome password can be used to prevent unauthorized users from starting the configuration
utility. The Enter Password screen appears when the command to start the configuration
utility is entered, if password protection is enabled.
ENTER PASSWORD
PASSWORD: ********
ABCDEFGHIJKLMNOPQRST
UVWXYZabcdefghijklmn
opqrstuvwxyz 0123456
789/-
CONTINUE
CANCEL
Users must enter the password before the Dome Configuration Menu displays. The password
may be from 1 to 8 characters long. To enter the password using SensorNet, RS-422, or
Manchester protocols:
1. Use the Pan/Tilt control to move the cursor around the character field.
2. Press Focus to enter the highlighted character.
If you need to change a character that has been entered:
· Zoom In moves the cursor to the right in the Password field.
· Zoom Out moves the cursor to the left in the Password field.
As each character in the password is selected, asterisks (*) appear in the Password field.
When you have finished entering the password, select Continue. If the correct password has
been entered, the Dome Configuration Menu appears. If the correct password was not
entered, the Enter Password screen remains on the monitor.
If you do not want to start the configuration utility, select Cancel to return to normal dome
operation.
IMPORTANT
If you forget the password, contact your Sensormatic Representative for assistance.
For information about programming and enabling password protection, see Chapter 6.
Blank Space
Character