Operator`s manual

Using the Dome Configuration Utility 1-5

Restoring Factory Settings

Some screens provide a choice to restore factory settings. This choice applies only to those

settings currently displayed on the screen. To reset all configuration settings, choose Reset

to Factory Settings from the Dome Configuration Menu. The following prompt appears:

Reset to Factory Settings

If you want to restore the factory settings, select Yes. If you do not want to restore the

factory settings, select No.

IMPORTANT

Selecting Reset to Factory Settings from the Dome Configuration Menu does not

change the following settings: Camera Name, Alarm Names, Area Names, Preset Names,

Pattern Names, Area Boundaries, Privacy Zones, and Presets. To reset names to the default

settings, see Chapter 5: Configuring Text Displayed On-Screen.

Exiting the Configuration Utility

Under SensorNet, RS-422, and Manchester protocols, you may save your changes and exit

the utility from any screen by pressing and holding Iris Close, then pressing Focus. From

the Dome Configuration Menu, you have two choices for exiting the utility: Exit and

Save Changes or Quit Without Saving. Use the Pan/Tilt control to move the highlight

bar up and down on the screen.

· If you want to keep the changes you made, move the highlight bar to Exit and Save

Changes, and select. The utility closes.

· If you want to exit without making changes, move the highlight bar to Quit Without

Saving, and select. The following prompt appears on the screen:

Data Not Saved. Quit Anyway?

To cancel the changes, select Yes. To keep the changes, select No. If you choose No, the

Dome Configuration Menu is displayed.

IMPORTANT

The following settings do not restore when selecting Quit Without Saving from the Dome

Configuration Menu: Area Boundaries, IR Mode, WDR (wide dynamic range), and

AGC/Shutter Limit.