Operator`s manual

EQUIPMENT MODIFICATION CAUTION

Equipment changes or modifications not expressly approved by Sensormatic Electronics Corporation, the

party responsible for FCC compliance, could void the user's authority to operate the equipment and could

create a hazardous condition.

FCC COMPLIANCE

This equipment has been tested and complies with the limits for a Class A digital device, according to Part 15

of the FCC Rules. These limits provide reasonable protection against harmful interference when the

equipment operates in a commercial environment. This equipment generates, uses, and can radiate radio

frequency energy, and, if not installed and used according to these instructions, may cause harmful

interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference. If this equipment is

used in a residential area, users must correct the interference at their own expense.

WARRANTY DISCLAIMER

Sensormatic Electronics Corporation makes no representation or warranty of the contents of this manual and

disclaims any implied warranties of merchantability or fitness. Sensormatic Electronics Corporation reserves

the right to revise this manual and change its content without obligation to notify any person of these

revisions.

LIMITED RIGHTS NOTICE

For units of the Department of Defense, all documentation and manuals were developed at private expense

and no part of it was developed using Government Funds. The restrictions governing the use and disclosure of

technical data marked with this legend are set forth in the definition of "limited rights" in paragraph (a) (15)

of the clause of DFARS 252.227.7013. Unpublished - rights reserved under the Copyright Laws of the United

States.

SOFTWARE LICENSE AGREEMENT

A Software License Agreement appears in Appendix S of this manual. Please read it carefully. Using the

SpeedDome Ultra VI Camera Dome Configuration Utility software indicates that you accept the terms and

conditions of this agreement.

No part of this manual may be reproduced in any form without written permission from Sensormatic

Electronics Corporation.

SpeedDome, Sensormatic and the Sensormatic logo are trademarks or registered trademarks of Sensormatic

Electronics Corporation. Product names mentioned herein may be trademarks or registered trademarks of

other companies.

PN-8000-2830-01, Rev. A1 (10/2001 - BSL)