Operator`s manual

Configuring Text Displayed On-Screen 5-11
5. Press Zoom to change the number. When the item whose name you want to change
appears press Focus Far.
Note: If Presets, Patterns, or Areas have been programmed, the dome automatically
points to the starting position of the associated selection each time the number is
advanced.
6. The Name Programming screen appears.
Figure 5-6: Example Name Programming Screen
NAME PROGRAMMING
CAMERA
NAME: CAMERA.............
ABCDEFGHIJKLMNOPQRST
UVWXYZabcdefghijklmn
opqrstuvwxyz 0123456
789/-
UNDO CHANGES AND QUIT
EXIT
/PRESET/PATTERN/AREA/ALARM
7. Move the blinking highlight around the available characters. When the correct character
is highlighted, press Focus to select it.
If you make a mistake, Zoom In moves the cursor one space right, and Zoom Out
moves the cursor one space left in the name.
8. Repeat step 7 until the name is complete.
9. Do one of the following:
· To save the name changes, select Exit.
· To discard the name changes, select Undo Changes and Quit.
10. Do one of the following:
· If you were changing the camera name, continue with step 12.
· If you were changing the name of an area, preset, pattern or alarm, the Select Name
to Program screen appears. Continue with step 11.
11. Do one of the following:
· To make additional changes to the same type of name selected in step 3, repeat steps 4
through 10.
· To return to the Name Configuration Menu, select Exit, and continue with step 12.
Blank Space
character