User's Manual

2-System Assembly and Startup pulseEKKO PRO
8
2.3.4 Attaching the Mounting Blocks to the Antennas
Attach the antenna mounting blocks to the antennas by using the flathead screwdriver to tighten the 4
(four) quarter-turn fasteners, ensuring that the male brass antenna pins protrude up the center holes of the
mounting blocks (Figure 2-10). Quarter-turn fasteners work by aligning the screw in the socket and then
pressing downward and tightening a quarter of a turn. DO NOT APPLY UNDUE FORCE. It is usually best
to have all four of the quarter-turn fasteners properly aligned in their sockets before tightening them. To do
this, put slight pressure on the quarter-turn fastener and rotate it until you feel it drop into the socket. Then
align the other three quarter-turn fasteners in the same manner. Once complete, go back and tighten all of
them.
Figure 2-10: Attach the mounting blocks to the top of the antenna using the 4 quarter-turn fasteners. Before doing so, make sure
that the 2 male brass antenna pins have been screwed into the top of the antenna first.