User's Manual

pulseEKKO PRO 2-System Assembly and Startup
11
2.3.7 Attaching Handles
2.3.7.1 Attaching the Adjustable Handles
Attach the adjustable handle to the antenna using the flat head screwdriver to tighten the 4 quarter-turn
fasteners as with the mounting block (Figure 2-14).
This handle can then be adjusted for height by loosening the 2 levers by hand, moving the handle to the
desired height and retightening the levers (Figure 2-15).
Figure 2-14: Attach the adjustable handles to the antennas by tightening the 4 quarter-turn fasteners. Adjust the height of the
handle by loosening the levers at the base of the handles (right) and pulling the handles up to the correct height.
Figure 2-15: Once the handles have been adjusted to the correct height, lock them into place by tightening the levers as shown on
the right.