User manual

Sensorsoft Alert User Manual
Figure 17: Configuring Command Line Alerts for a Scalar Variable
In the example shown in Figure 17, above, the Alert appliance will turn ON a relay connected to port
4 when the reading exceeds the Scalar Critical High Limit, and will turn OFF the relay when the
reading returns to normal.
4. In order to turn a relay on, you will need to enter the following command in the Command field:
scom -Q /bin/SR6171_ON.ini ttyS4
In order to turn a relay off, you will need to enter the following in the Command field:
scom -Q /bin/SR6171_OFF.ini ttyS4
42