User's Manual
Table Of Contents
- Sensus AR5000 User’s Guide
- Contents
- About the AR5000
- Device Care & Handling
- Use the Hand-Held Device
- Configuring the AR5000
- Link the AR5000 to a TouchRead Device (SmartGun/AutoGun)
- To link a TouchRead device...
- Change the Display Font & Size
- To change the font and size...
- Adjust the Display
- To switch the backlight on/off...
- To adjust the contrast on the screen...
- View the Battery Status
- To view the battery status...
- View the Current HHD ID & User
- To view the HHD and operator IDs...
- View the Date & Time
- To view the date and time...
- Set Up & Use the Communication Stand
- Charge the AR5000
- Contact Customer Support
- Collect Meter Data
- Start Collecting Data
- Manage Reading Scenarios
- Enter Data
- Enter Manual Readings
- To enter a manual reading...
- Enter TouchRead Readings
- To enter a TouchRead...
- Enter RadioRead Readings (AR5002 only)
- To enter a RadioReading...
- Enter Notes
- To enter a note...
- Mark Locations
- To Mark/Unmark an address...
- Answer Questions
- To answer a question...
- Add New Meters to Route
- To add a new meter ID...
- Find Route Information
- About the AR5000
- Index
1–10 Sensus Metering Systems
Chapter 1: About the AR5000
equipment at the start of the shift. However, you should
always verify that the gun and the AR5000 are linked. If they
are not, you need to perform the following procedure.
Configuration Menu To link a TouchRead device...
1 Open the Configuration menu.
• If you have just removed the AR5000 from the charging
stand, the system automatically displays a Startup
Screen.
Use the PgUp/PgDn key to highlight Configuration on
the Startup Screen. Press the Enter key. The system
displays the Configuration Menu.
• While you are working on a route, press the F6 key. The
system displays the Configuration Menu
2 Use the PgUp/PgDn key to select Smart/AutoGun Utilities.
Smart/AutoGun Utilities
Screen
3 Press the ENTER key.
The system displays the Smart/AutoGun Utilities screen.
4 Use the PgUp/PgDn key to highlight Link To AutoGun.
5 Press the ENTER key.
Note
F6 is the default key assignment for the
Configuration menu. Key assignments can be
changed. For more information, see About the
Key Controls/Functions.