User's Manual
Table Of Contents
- Sensus AR5000 User’s Guide
- Contents
- About the AR5000
- Device Care & Handling
- Use the Hand-Held Device
- Configuring the AR5000
- Link the AR5000 to a TouchRead Device (SmartGun/AutoGun)
- To link a TouchRead device...
- Change the Display Font & Size
- To change the font and size...
- Adjust the Display
- To switch the backlight on/off...
- To adjust the contrast on the screen...
- View the Battery Status
- To view the battery status...
- View the Current HHD ID & User
- To view the HHD and operator IDs...
- View the Date & Time
- To view the date and time...
- Set Up & Use the Communication Stand
- Charge the AR5000
- Contact Customer Support
- Collect Meter Data
- Start Collecting Data
- Manage Reading Scenarios
- Enter Data
- Enter Manual Readings
- To enter a manual reading...
- Enter TouchRead Readings
- To enter a TouchRead...
- Enter RadioRead Readings (AR5002 only)
- To enter a RadioReading...
- Enter Notes
- To enter a note...
- Mark Locations
- To Mark/Unmark an address...
- Answer Questions
- To answer a question...
- Add New Meters to Route
- To add a new meter ID...
- Find Route Information
- About the AR5000
- Index
1–18 Sensus Metering Systems
Chapter 1: About the AR5000
Set Up & Use the Communication Stand
The communication stand serves two functions for the
AR5000. First, the stand provides a connection that the office
staff uses to transfer and synchronize files between the
AR5000 and an office computer. Second, the stand charges
the AR5000’s battery.
AR5000 Communication Stand Typically, office staff are the only people involved in
transferring and synchronizing information on the office PCs
and the AR5000. You should only need to verify that the
system battery is properly charged (see
Charge the AR5000
on page 1-22).
This section provides information on how to connect the
communication stand and is divided under the following
headings:
•
Connect the Stand
on page 1-18 - How to connect the
communication stand to AC power and an office PC.
•
Mount the Stand
on page 1-20 - How to mount a
communication stand on a wall.
•
Place the AR5000 in the Stand
on page 1-21 - How to
verify that the stand is operating properly.
 Connect the Stand
When you first setup the communication stand, you need to
make three cable connections - AC power, PC communication,
and communication to another stand. Once you have setup
and successfully connected the communication stand(s), you
only need to place the AR5000 into the stand to have it