User's Manual
Table Of Contents
- Sensus AR5000 User’s Guide
- Contents
- About the AR5000
- Device Care & Handling
- Use the Hand-Held Device
- Configuring the AR5000
- Link the AR5000 to a TouchRead Device (SmartGun/AutoGun)
- To link a TouchRead device...
- Change the Display Font & Size
- To change the font and size...
- Adjust the Display
- To switch the backlight on/off...
- To adjust the contrast on the screen...
- View the Battery Status
- To view the battery status...
- View the Current HHD ID & User
- To view the HHD and operator IDs...
- View the Date & Time
- To view the date and time...
- Set Up & Use the Communication Stand
- Charge the AR5000
- Contact Customer Support
- Collect Meter Data
- Start Collecting Data
- Manage Reading Scenarios
- Enter Data
- Enter Manual Readings
- To enter a manual reading...
- Enter TouchRead Readings
- To enter a TouchRead...
- Enter RadioRead Readings (AR5002 only)
- To enter a RadioReading...
- Enter Notes
- To enter a note...
- Mark Locations
- To Mark/Unmark an address...
- Answer Questions
- To answer a question...
- Add New Meters to Route
- To add a new meter ID...
- Find Route Information
- About the AR5000
- Index
Sensus AR5000 User’s Guide 3-3
Search the Route
Search the Route
Routes are primarily an organized list of individual locations
and their associated meter IDs. The locations are listed in a
logical order to match the path that you could take as you
physically move from one location to the next. Typically, you
start at one end of the route and move through the list,
entering readings until you reach the end of the route.
However, there are times you may need to locate a specific
address or meter on the route. This could happen if you take
the route out of order or need to verify an address, reading,
or specific text associated with a specific address.
The AR5000 has a set of features that you can use to search
for addresses, meter IDs, and specific displayed text.
Find instruction for these tasks in this section:
•
Search for an Address
on page 3-4 - How to display a
specific address on a route.
•
Go to the First Address
on page 3-5 - How to display the
first address on a route.
•
Go to the Last Address
on page 3-6 - How to display the
last address on a route.
•
Search for a Meter ID
on page 3-8 - How to display the
location information for a specific meter ID.
Note
Some addresses may have multiple meters
(ex.: apartment buildings or industrial sites).
Typically, each meter is listed at a separate
location on a route.
Note
Once you find an address, you can perform
any of the functions described in Chapter 2:
Collect Meter Data.