User's Manual
Table Of Contents
- Sensus AR5000 User’s Guide
- Contents
- About the AR5000
- Device Care & Handling
- Use the Hand-Held Device
- Configuring the AR5000
- Link the AR5000 to a TouchRead Device (SmartGun/AutoGun)
- To link a TouchRead device...
- Change the Display Font & Size
- To change the font and size...
- Adjust the Display
- To switch the backlight on/off...
- To adjust the contrast on the screen...
- View the Battery Status
- To view the battery status...
- View the Current HHD ID & User
- To view the HHD and operator IDs...
- View the Date & Time
- To view the date and time...
- Set Up & Use the Communication Stand
- Charge the AR5000
- Contact Customer Support
- Collect Meter Data
- Start Collecting Data
- Manage Reading Scenarios
- Enter Data
- Enter Manual Readings
- To enter a manual reading...
- Enter TouchRead Readings
- To enter a TouchRead...
- Enter RadioRead Readings (AR5002 only)
- To enter a RadioReading...
- Enter Notes
- To enter a note...
- Mark Locations
- To Mark/Unmark an address...
- Answer Questions
- To answer a question...
- Add New Meters to Route
- To add a new meter ID...
- Find Route Information
- About the AR5000
- Index
3–12 Sensus Metering Systems
Chapter 3: Find Route Information
Find Unfinished Sections of the Route
At the end of reading a route, you can search to verify that all
of the tasks are complete for that route. You can find meters
without any new reading data, addresses that have no new
data, and questions that have not been answered.
The following list provides a brief description of each part of
this section:
•
Find UnRead Meters
on page 3-12 - How to locate meters
on the route that do not have any new reading data.
•
Find UnVisited Location
on page 3-13 - How to find
locations along the route that have not had any activity.
•
Find Unanswered Questions
on page 3-15 - How to find
questions that have not received any response.
 Find UnRead Meters
The AR5000 typically associates read information with a
meter ID (see
Manage Reading Scenarios
on page 2-7).
When you reach the end of a route you may want to verify
that all of the meters have readings associated with them. At
any time during the reading process, you can use the search
function to check which meter IDs are still unread.
Search Route... Menu To find unread meters...
1 Open a route.
See
Start Collecting Data
on page 2-2 for instructions on
opening a route.
2 Press the F3 key.
Note
Once you find a location or a question, you can
perform any of the functions described in
Chapter 2: Collect Meter Data.