User's Guide

FPGMR User’s Guide VO.1 6 OF 8 03-17-06
TO BE USED ONLY FOR THE PURPOSE FOR WHICH IT IS SUBMITTED. ALL RIGHTS RESERVED TO SENSUS METERING
SYSTEMS. REPRODUCTION WITHOUT WRITTEN CONSENT IS PROHIBITED.
Section
3
Installation Process
After the GPS LINK OK LED turns green, you may begin the installation process. Start
by holding the Installation Tool vertically on the right side of the meter making sure the
command meter arrow on the left of the Installation tool is lined up with the center of the
electric meter as shown below.
3.1 Installation Button
Installation: Once the installation tool is in position, use the install meter button to begin
the setup process. Once the process has begun, the Handheld Device must be kept in
place until the installation is complete.
Install
Meter
Button