Quick Guide
GQG-10005-01
FlexNet® SmartPoint® C&I Gas Transceiver Module
Warnings & Hazards
ATTENTION
Any modications made to this device that are not approved by
Sensus may void the authority granted to the user by the FCC to
operate equipment.
ATTENTION
For Class B - Unintentional Radiators:
is device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference and (2) this device must accept any in-
terference received, including interference that may cause undesired
operation.
ATTENTION
ICES-003 Class B Notice—Avis NMB-003, Class B
is Class B digital apparatus complies with Canadian ICES-003.
WARNING
If you are not sure of the rated power of your radio, contact your
Sensus representative or dealer and supply the product model num-
ber found on the product label. If you cannot determine the rated
power out, then assure 20cm separation from the body to the device.
WARNING
e antenna used for this transmitter must not be co-located in con-
junction with any other antenna or transmitter.
WARNING
ere is danger of explosion if batteries are mishandled or incorrect-
ly replaced. On systems with replaceable batteries, replace only with
the same manufacturer and type or equivalent type recommended
per the instructions provided in the product service manual.
Do not disassemble batteries or attempt to recharge them outside
the system. Do not dispose of batteries in re.
Dispose of batteries properly in accordance with the manufacturer’s
instructions and local regulations.
ATTENTION
Note: is equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. ese limits are designed to provide reasonable protection
against harmful interference in a residential installation. is
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit dierent
form that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for
help
RADIATION HAZARD
In order to satisfy the FCC/ISED RF exposure limit for transmitting
devices, a separation distance of 20cm (7.8 inches) or more should
be maintained while operating the Sensus GFLCI and GFL3CI. To
ensure compliance, operations at closer than this distance are not
recommended. is minimum safe distance is required between
personnel and this antenna of this device.
ATTENTION
is device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause unde-
sired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes: (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit ac-
cepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.