User's Manual

AMR Transmitter Mounting Instructions for American Meter

AC250, AL175, AL250, AL5B, AL225, AL425

Mount Transmitter on meter

Insure the four (4) mounting screws are available and within reach.

Place the AMR Transmitter onto the gas meter, aligning the Transmitter’s shaft

with the gas meter’s male or female wriggler; adjust the Transmitter shaft’s

position by holding it on the front side, and insert pin into hole.

While holding the Transmitter in place, check that the shafts are aligned by

gently rotating the Transmitter’s shaft with your other hand. There should be

just a slight freedom of motion.

Attach the Transmitter to the meter using the four (4) mounting screws with

#3 Phillips screwdriver. Place all screws, then torque down two (2) diagonal

screws. Check shaft alignment again, then tighten the last two (2) screws.

Should two (2) or more screws shear or strip during the installation, the

meter will need to be replaced by a qualified utility representative. Remove

the transmitter and reinstall the index and index cover on the meter with the

original screws. Enter the appropriate information in the Mint HHT and skip

to the next work order.