User's Manual

ManualsBrandsSensus Metering Systems ManualsElectronicsDTS/FHSS Transceiver

Invensys Metering Systems Page 1 of 7

Invensys Metering Systems, ICG – Robert

Shaw Radio Quick-Start Guide

8 October 2003

This document contains proprietary information. It may not be copied,

transmitted or distributed, in whole or in part, without the consent of Invensys

Metering Systems.

Summary of content (7 pages)

PAGE 1
Invensys Metering Systems, ICG – Robert Shaw Radio Quick-Start Guide 8 October 2003 This document contains proprietary information. It may not be copied, transmitted or distributed, in whole or in part, without the consent of Invensys Metering Systems.
PAGE 2
Test Plan Contents Contents..................................................................................................................... 2 1 INTRODUCTION.................................................................................................. 4 2 SETUP PROCEDURES ....................................................................................... 4 3 EXAMPLE............................................................................................................
PAGE 3
Test Plan FCC Compliance NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
Test Plan Introduction This document contains instructions for setting up communication between multiple Robert Shaw radios for testing purposes, and describes the use of the InvenStack test software. 1 Setup Procedures 1. Connect the radio to the RS232 interface/control board via the 10 pin connectors with a ribbon cable as shown in the photograph fig 1. Make sure that pin 1 on the interface board is connected to pin 1 on the radio (both are near the edge of the board).
PAGE 5
Test Plan fig 2. Setting up PanID and Local Address in DLME tab 6. Set up the log file if desired in the logging menu. 7. Under the FileMessages tab, browse to select individual files or batch files to run to begin sending messages between radios. Each file contains a command, the batch files can be used to loop or send consecutive commands with a userdetermined delay between each. 2 Example The text below is from the message file DL_DATA_REQUEST_ACK_1.TXT. This will send a DL_DATA_request command.
PAGE 6
Test Plan the received message match those set in the receiving radio. The original sender will accept that ACK generated by the receiving radio if and only if the SrcPanID and SrcAddr in the original message are correct. Below are a few steps that can be followed to verify proper communication and a couple of screenshots that show the resulting messages in the test applications message windows. The file DL_DATA_REQUEST_ACK_1.TXT contains the following text. In the screenshot in fig.
PAGE 7
Test Plan fig. 3 InvenStack Test application – Radio 0001, 01 just sent message fig.