User's Manual
Sensys Networks and the Sensys Networks logo are trademarks of Sensys Networks, Inc. All other trademarks are the property of their respective owners.
Information contained herein is believed to be reliable, but Sensys Networks makes no warranties as to its accuracy or completeness.
Copyright © 2014 Sensys Networks, Inc. • ALL RIGHTS RESERVED • P/N 152-240-020-016 Rev D
Local Distributor
Quick Start Guide: FLEX-RP-B/FLEX-RP-B-LL
Congure Repeater (cont.)
If the repeater is connected to an external antenna,
then it can be congured via the Adv tab. From the
Antenna window, select either Upstream (to AP) or
Downstream (to sensors) to congure the external
antenna.
Note: Recommended setting for external antenna is
Downstream (to sensors).
Adv Tab
• Internal antenna is not listed on the panel, but will
automatically be assigned to the unchecked option.
• A failsafe error message will occur should you
choose both options.
• If FLEX-RP-B/FLEX-RP-B-LL is installed with
or without the external antenna, and the Adv tab
options are left unchecked, the internal antenna
will be used for both Upstream and Downstream
channels.
• If Discover Mode is not on the following warning
will display: Advanced setting values are either not
set or last known current value because discover
not on. Value(s) will not be updated until discover
on.
• If Discover Mode is off at connection time for
TrafcDOT the Adv tab will display Not Set values.
Turn on Discover Mode for true values to display.
Refer to Sensys Network VDS240 Wireless Vehicle Detection
System TrafcDOT v2.10 Set Up and Operating Guide for
more information.
Adv Tab Notes
Click Apply to accept conguration changes. Click
SAVE at the top of the screen to save changes
made to the access point.
Save Conguration