User's Manual

Sensys Networks and the Sensys Networks logo are trademarks of Sensys Networks, Inc. All other trademarks are the property of their respective owners.
Information contained herein is believed to be reliable, but Sensys Networks makes no warranties as to its accuracy or completeness.
Copyright © 2014 Sensys Networks, Inc. • ALL RIGHTS RESERVED • P/N 153-240-020-013 Rev C
Local Distributor
Functional Specications Power, Physical, & Environmental
Compliance
interfaces
• to/from sensors via 802.15.4 PHY
radio
• to/from repeaters via 802.15.4 PHY
radio
• to/from access point via 802.15.4
PHY radio
over-the-air
protocol
Sensys Networks NanoPower (SNP)
protocol (TDMA)
physical layer
protocol
IEEE 802.15.4 PHY
modulation
Direct Sequence Spread Spectrum
Offset Quadrature Phase-Shift Keying
(DSSS O-QPSK)
transmit/receive
bit rate
250 kbps
frequency band
2400 to 2483.5 MHz
(ISM unlicensed band)
frequency
channels
16
channel
bandwidth
2 MHz
internal antenna
type
microstrip patch antenna (behind
front face panel)
antenna eld of
view
±60° (azimuth & elevation)
nominal output
power
3 dBm
spurious emissions
• 30 - 1000 MHz: < -36 dBm
• 1 - 12.75 GHz: < -30 dBm
• 1.8 - 1.9 GHz: < -44 dBm
• 5.15 - 5.3 GHz: < -47 dBm
typical receive
sensitivity
-101 dBm (PER ≤ 1%)
saturation
(max input level)
≥ 10 dBm
power supply
• FLEX-RP-B:
– Li-SOCl2 3.6V battery pack
◦ nominal capacity: 57 Ah
• FLEX-RP-B-LL:
– Li-SOCl2 3.6V battery pack
◦ nominal capacity: 171 Ah
recommended
battery/unit
replacement
• FLEX-RP-B: battery replacement every 2
years
• FLEX-RP-B-LL: unit replacement every
7 years
dimensions
• FLEX-RP-B: 6.50” x 6.55” x 6”
(16.5 cm x 16.6 cm x 15.2 cm)
• FLEX-RP-B-LL: 6.50” x 6.55” x 6”
(16.5 cm x 16.6 cm x 15.2 cm)
• FLEX-ANT-1: 5.65” x 3.54” x 4.80”
(14.4 cm x 9 cm x 12.2 cm)
• FLEX-ANT-2: 9.5” x 9.5” x 4.38”
(24.10 cm x 24.10 cm x 11.10 cm)
weight
• FLEX-RP-B: 2.31 lb ( 1.05 kg)
• FLEX-RP-B-LL: 2.62 lb ( 1.19 kg)
• FLEX-ANT-1: 0.94 lb ( 0.43 kg)
• FLEX-ANT 2: 2.2 lb (1 kg)
environmental
• designed for weatherproof, outdoor
operation
• NEMA Type 4x enclosure
• IP65 ingress protection
operating temp
-40ºF to 176ºF / -40ºC to +80ºC
safety
2006/95/EC
EMC
• FCC: This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. Changes or
modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
• CE0678
• 2004/108/EC
FLEX-RP-B/FLEX-RP-B-LL
Products
Descriptions
FLEX-RP-B
FLEX Repeater with internal battery pack
FLEX-RP-B-LL
FLEX Repeater with long-life battery pack
FLEX-ANT-1
FLEX Standard External Antenna
FLEX-ANT-2
FLEX Long Range External Antenna
Available Products