Quick Start Guide

1608 4th Street Suite 200 Berkeley CA 94710
|
[e-mail]
|
P 510.548.4620 F 510.548.8264
Quick Start Guide: FlexRadio Cabinet
Install the plastic washer (a) onto
the threaded ferrule. Ensure the
ange on the washer is seated on
the ¾ inch hole. The at side of
the washer contacts the nut.
Add Washer
Drill a hole ¾ inches ( 1.9 cm) diameter for aluminum ferrule antenna on top of the at
surface of the trac cabinet with a hole saw or a step drill bit where the omni directional
antenna will be installed.
Note: Ensure the antenna hole location will not interfere with the trac cabinet inside.
Drill a Hole in Trafc Cabinet
3
Install Omni Directional Antenna
Pass the connectors through the hole. Pull the cable
until the threaded end of the antenna ferrule appears
in the hole. DO NOT pull on connectors. Pulling on
the connectors may cause them to detach or may cause
internal damage to the cable connection.
Thread Connectors into Cabinet
a
Please refer to Bolt-On Antenna Installation Guide -
Slotted Washer & Nut that is provided in the antenna
packaging for more details.
Omni Directional Antenna Installation
DRAFT