Quick Start Guide
Sensys Networks and the Sensys Networks logo are trademarks of Sensys Networks, Inc. All other trademarks are the property of their respective owners.
Information contained herein is believed to be reliable, but Sensys Networks makes no warranties as to its accuracy or completeness.
Copyright © 2017 Sensys Networks, Inc. • ALL RIGHTS RESERVED • P/N 152-240-XXX-XXX Rev A
Local Distributor
Quick Start Guide: FlexRadio Cabinet
Install Omni Directional Antenna (cont.)
3
Connect Cables to the FlexRadio Cabinet
4
Connect the RP TNC male end to the
FlexRadio cabinet.
WARNING: DO NOT OVER BEND
CABLE. Do not bundle excess cable; only
loop with bend radius no smaller than 6
inches (15.2 cm).
Connect the Antenna to FlexRadio Cabinet
Connect FlexRadio Cabinet module to FlexControl Module
using CAT5 (or better) straight-through cables via TO: SPP
PORT on the FlexRadio Cabinet module and the SPP-0 (or
SPP-1) port on the FlexControl Module.
Power FlexRadio Cabinet
Install nut on threaded ferrule. Hand tighten the nut until it contacts
the plastic washer. Use a wrench to tighten the nut two more turns to
secure the antenna and to seat the antenna’s gasket.
Secure Nut
Notice: Any changes or modications not expressly approved by
Sensys Networks could void the user’s authority to operate the
equipment. The external antenna must have gain less than +6dBi to
meet regulatory requirements.
DRAFT