User's Manual

1608 4th Street Suite 200 Berkeley CA 94710
|
www.sensysnetworks.com/resources
|
P 510.548.4620 F 510.548.8264
Congure Repeater
Select a repeater from the image map
to access the Repeater Conguration
window with the Info tab open. The
Name eld allows the repeater’s name
to be user-dened.
Note: Repeater’s rmware version is for
reference only.
Repeater Conguration Window
3
Select an upstream channel by clicking
the Cong tab. Select an entry for the
Current Upstream Ch eld by clicking on
the Change to drop-down list.
Specifying Upstream Channel
Select a entry for the Current
Downstream Ch eld by clicking the
Change to drop-down list.
Specifying Downstream Channel
• The default radio channel for access
point to repeater communications is 4.
• The default radio channel for repeater to
sensor communications is 5.
• Never use the same channel for
both access point and sensor
communications.
Refer to Sensys Network VDS240 Wireless
Vehicle Detection System TracDOT Set Up
and Operating Guide for more information.
Channel Notes
• When an installation contains multiple
repeaters with more than 20 sensors,
changing one or more repeaters from
Current Cong 0 to Current Cong 1
allows the access point to communicate
with up to 40 sensors through the
repeaters.
Refer to Sensys Network VDS240 Wireless
Vehicle Detection System TracDOT Set Up
and Operating Guide for more information.
Cong Notes
Quick Start Guide: FlexNode Line Powered Radio (NA)