User's Manual

Sensys Networks and the Sensys Networks logo are trademarks of Sensys Networks, Inc. All other trademarks are the property of their respective owners.
Information contained herein is believed to be reliable, but Sensys Networks makes no warranties as to its accuracy or completeness.
Copyright © 2017 Sensys Networks, Inc. • ALL RIGHTS RESERVED • CONTENTS SUBJECT TO CHANGE
Local Distributor
• A failsafe error message occurs should you
choose the external antenna option when there
is no external antenna installed.
• If FlexNode Line Powered is installed with or
without the external antenna, and the Antenna
panel options are left unchecked, the internal
antenna is used for both
To AP and To Sensors
channels.
• If Discover Mode is not ON the following
warning will display: Advanced setting values
shown are either not set or last known current
value because discover not on. Value(s) will
not be updated until discover turned on.
• If Discover Mode is OFF at connection time for
TrafficDOT the Adv tab displays Not Set values.
Turn Discover Mode ON for true values to
display.
Refer to Sensys Network VDS240 Wireless
Vehicle Detection System TracDOT Set Up and
Operating Guide for more information.
Adv Tab Notes
Congure Repeater (cont.)
If the repeater is connected to an external antenna, then it can be
congured via the Adv tab. From the Antenna panel, select either To
AP or To Sensors to congure an internal/external antenna.
Note: Recommended setting for external antenna is To Sensors.
Adv Tab
Click Apply to accept conguration
changes.
Click SAVE at the top of the screen to
save changes made to the access point.
Save Conguration
Quick Start Guide: FlexNode Line Powered Radio (NA)