User's Manual

SENTON Enterprises Limited 信 通 企 業 有 限 公 司
Flat 10, 17/F, Fo Tan Industrial Centre, 香港沙田火炭坳背灣街 26-28 號
26-28 Au Pui Wan Street, Fo Tan, Shatin, N.T., Hong Kong 富騰工業中心 17 樓 10 室
Tel: [phone] Fax: [phone] 電話: (八五二) 二六八七 一七一二 (四線)
E-mail address: [e-mail] 傳真: (八五二) 二六八七 四一二五
12 032104A-1
procedures discussed in “Placing a Call” when to place and receive a call.
Note: The headset jack of your cordless telephone is compatible with 2.5mm headset plugs
only. When you plug in the headset into the headset jack, it automatically mutes the
microphone and speaker of the handset. Unplug the headset to return the handset to normal
use.
INITIAL SETUP
Please follow these steps before using the cordless telephone for the first time.
1. Ensure that the handset battery pack is installed and charged fully for at least 14 hours.
2. Ensure that all connections(line cord and adaptor cord) are properly inserted into rear
of the base unit.
SETTING THE TONE/PULSE MODE
Select the appropriate dialing service by moving the (TONE/PULSE switch at the bottom of
the base unit:
· (T) TONE for Tone service , or
· (P) PULSE for Rotary service.
SETTING THE HANDSET RINGER ON/OFF MODE
The handset must be set to ring ON mode in order to ring when receiving an incoming call.
See Programs Operation section on “RING ON/OFF SETTING
TELEPHONE OPERATION
Place a Call
1. Pick up the handset and press the TALK button. The Call Timer starts to count. The
base unit IN USE LED indicator will light up.
2. Listen for a dial tone.
3. Dial the telephone number. The phone numbers appear on the LCD Display as you
enter the number.
4. When finished with your call, press the TALK button or place the handset on the base
unit.
Handset Jac
k
(Figure 7)