User's Manual

SENTON Enterprises Limited 信 通 企 業 有 限 公 司
Flat 10, 17/F, Fo Tan Industrial Centre, 香港沙田火炭坳背灣街 26-28 號
26-28 Au Pui Wan Street, Fo Tan, Shatin, N.T., Hong Kong 富騰工業中心 17 樓 10 室
Tel: [phone] Fax: [phone] 電話: (八五二) 二六八七 一七一二 (四線)
E-mail address: [e-mail] 傳真: (八五二) 二六八七 四一二五
8 032104A-1
MENU/MUTE – While in standby mode, this button allows you to set the handset in
Programming mode. In talk mode, this button allows you to temporarily disable the handset
microphone.
Receiver – Allows you to hear calls.
BASE UNIT CONTROLS:
Base Antenna - A fixed antenna.
Base Unit Charge Terminals - Used for charging handset batteries. We recommend that
you clean these contacts periodically with an alcohol-moistened cloth or cotton swab.
IN USE/CHARGE LED Indicator - Lights up to indicate the unit is ON or when the
handset is placed on the base unit for charging. It flashes to indicate the page function is in
use.
PAGE Butto n - Allows you to locate the handset when it is not on the base, or to alert the
person near the handset.
TONE/PULSE Switch - A switch located on the bottom of the base unit, which allows you
to set the dialing mode to either Tone dialing or Pulse(rotary) dialing.
DC 9V jack - A jack located on the rear side of the base unit used for connecting the AC
adaptor to the base unit.
TEL LINE jack – Accepts line cord to make connection with modular type telephone
outlet.
INSTALLATION
CAUTION:USE ONLY THE NICKEL CADMIUM(Ni-Cd) BATTERY TYPE
INCLUDED WITH THIS UNIT. USE OF OTHER BATTERY TYPES MAY CAUSE
INJURIES OR DAMAGE.
Battery Installation
1. Remove the battery compartment cover of the handset by pressing the top of the cover
and sliding it down.
2. Connect the Ni-Cd battery pack plug along the slot into the handset’s battery