User's Manual

SENTON Enterprises Limited 信 通 企 業 有 限 公 司
Flat 10, 17/F, Fo Tan Industrial Centre, 香港沙田火炭坳背灣街 26-28 號
26-28 Au Pui Wan Street, Fo Tan, Shatin, N.T., Hong Kong 富騰工業中心 17 樓 10 室
Tel: [phone] Fax: [phone] 電話: (八五二) 二六八七 一七一二 (四線)
E-mail address: [e-mail] 傳真: (八五二) 二六八七 四一二五
13 032104A-1
NOTE: The call timer will start to count once you press the TALK button.
Receive a Call
NOTE: If you are expecting incoming calls, the handset must be programmed to RING ON
mode.
If the handset is on the base
:
1. When the phone rings, simply pick up the handset from the base cradle if the unit is set
to auto-answer ON mode. If the unit is set to auto-answer OFF mode, press the TALK
button. See the “AUTO ANSWER ON/OFF” section to set auto-answer mode. The
LCD Display will show “TALK”.
2. Start your conversation.
3. To end your conversation, either press the TALK button or place the handset on the
base unit.
If the handset is out of the base:
1. When the phone rings, press the TALK button on the handset. The LCD Display will
show “ TALK” and the base unit IN USE LED will light up.
2. Start your conversation.
3. To end your conversation, either press the TALK button or place the handset on the
base unit.
Last Number Redial
A. AFTER HEARING A BUSY TONE WHEN PLACING A CAL.L
1. If you get a busy tone, press handset TALK button to hang up.
2. Press the handset TALK button again and listen for a dial tone.
3. Press the handset RE/PA/DEL button. This will automatically redial the last telephone
number you called (up to 32 digits).
4. When finished with your call, press the TALK button or place the handset on the base
unit.
B. WHEN THE HANDSET IS OFF THE BASE UNIT AND IN STANDBY MODE
1. Press the TALK button on the handset and listen for a dial tone.
2. Press the RE/PA/DEL button. This will automatically redial the last telephone number
you called (up to 32 digits).
3. When finished with your call, press the TALK button or place the handset on the base
unit.
SAVING IN THE PHONEBOOK
1. Press the SA/MEMO button.
2. Press the FLASH/EDIT button.