User's Manual

SENTON Enterprises Limited 信 通 企 業 有 限 公 司
Flat 10, 17/F, Fo Tan Industrial Centre, 香港沙田火炭坳背灣街 26-28 號
26-28 Au Pui Wan Street, Fo Tan, Shatin, N.T., Hong Kong 富騰工業中心 17 樓 10 室
Tel: [phone] Fax: [phone] 電話: (八五二) 二六八七 一七一二 (四線)
E-mail address: [e-mail] 傳真: (八五二) 二六八七 四一二五
041504A-1 33
button again to go back to “AM”.
10. Press “TIME SET” button to confirm. The new day and time will announced.
SETTING REMOTE CODE
1. Press CODE button(on the base). Then you will hear the current setting, “one, two, three”.
2. Press and hold “code” button for about 3 seconds.
3. Press Skip
or Repeat button (on the base) to select the first digit you desired.
4. Press the CODE button to confirm.
5. Press Skip
or Repeat button to select the second digit you desired.
6. Press the CODE button to confirm.
7. Press Skip
or Repeat button to select the third digit you desired.
8. Press the CODE button to confirm.
You will hear the newly programmed 3-digit security code.
NOTE: When the Excursion
®
35178 is disconnected the AC Adaptor from the base beyond five hours, the
code will be returned to the original setting “123”.
OUTGOING MESSAGE (OGM)
This is the announcement callers will hear when Excursion
®
35178 answers a call. The Excursion
®
35178
also has a default OGM(factory preset) which is active when there is no OGM present.
Default OGM: “Please record your message after the beep.”
RECORDING THE OUTGOING MESSAGE(OGM)
Outgoing Message(OGM) is recorded remotely on the handset. The maximum recording time is 30
seconds.
1. In standby mode, press the REMOTE button on the handset. The Excursion
®
35178 will prompt .
2. Press 3 button. The Excursion
®
35178 will prompt “Please record your announcement after the beep.
3. After hearing a long beep, begin your announcement.
4. Press 5 button to stop recording and the Excursion
®
35178 will playback once automatically for your
review.
5. Press the REMOTE button to exit the remote mode. Otherwise, the unit will automatically turn off if
not in use for 8 seconds.
Outgoing Message(OGM) is recorded on the base unit. The maximum recording time is 30 seconds.
1. In standby mode, Press the OGM button.
2. Press and hold the OGM button.
3. Record your greeting after you hear a beep tone.
4. Release the OGM button after you finish recording your greeting. Your recorded greeting will be
played after releasing the button for user’s confirmation.
CHECKING THE OUTGOING MESSAGE (OGM)