User's Manual

SENTON Enterprises Limited 信 通 企 業 有 限 公 司
Flat 10, 17/F, Fo Tan Industrial Centre, 香港沙田火炭坳背灣街 26-28 號
26-28 Au Pui Wan Street, Fo Tan, Shatin, N.T., Hong Kong 富騰工業中心 17 樓 10 室
Tel: [phone] Fax: [phone] 電話: (八五二) 二六八七 一七一二 (四線)
E-mail address: [e-mail] 傳真: (八五二) 二六八七 四一二五
041504A-1 41
Can not access Remote
Operation
• The password you have entered may be incorrect. Enter the correct
password during OGM playback or within 7 seconds after the OGM
has finished playing.
B. CALLER ID SYSTEM TROUBLESHOOTING TABLE
SYMPTOM SOLUTION
The Caller ID panel
is blank
• Check the power connection.
• Check the telephone line cord connections.
• Check the batteries for proper installation.
The Caller ID does
not show the caller’s
name and/or phone
number
• The Caller ID unit will not function until you have Caller ID service
provided by your local phone company. Call your local phone company
to have Caller ID installed on your telephone line.
• If you pick up the phone before the second ring, the caller information
will not be correctly received. If you have telephone answering
device(TAD) connected with the unit, set the TAD to answer after two
rings or more.
• If it is a blocked call or an out-of-area call, the caller’s name and/or
phone number will not appear on the display.
• If only the caller’s phone number appears on the display, it may be
Single Data Message Format(SDMF) call, as opposed to a Multiple
Data Message Format (MDMF) call. Please call your local phone
company to see which service you have.
Random characters
and/or “NO DATA”
appear on the LCD
display
• On rare occasions, the Caller ID information sent by the telephone
company may have an error in the transmission. This is not the fault of
your Caller ID unit. It can only capture and store the data that was
received.
Cannot get call
Waiting identification
on the LCD panel
• Subscription to Caller ID Call Waiting (CIDCW) is required from your
local phone company for the CIDCW function to operate properly. Call
you local phone company for details.
NOTE: On rare occasions, the system may fail to operate due to a power surge. To reset the system -
disconnect the AC Adaptor from the base then reconnect it.