User's Manual

SENTON Enterprises Limited 信 通 企 業 有 限 公 司
Flat 10, 17/F, Fo Tan Industrial Centre, 香港沙田火炭坳背灣街 26-28 號
26-28 Au Pui Wan Street, Fo Tan, Shatin, N.T., Hong Kong 富騰工業中心 17 樓 10 室
Tel: [phone] Fax: [phone] 電話: (八五二) 二六八七 一七一二 (四線)
E-mail address: [e-mail] 傳真: (八五二) 二六八七 四一二五
041504A-1 14
Wall Mounting (No Standard Wall Jack)
1. Drill two holes with a vertical distance between the two marked positions of 3
15/16”
（100mm）as
shown in Figure 4.
(Figure 4)
2. Drive a screw into each of the holes. Tighten them to the end of the screw lines, only leaving the
smooth part of the screw head outside the wall.
3. Hand the unit onto the screws, then slide it down firmly to fasten the base securely.
Uninstalling the Wall Mount Bracket
To remove the wall mount bracket from the base unit, pull it front as shown in Figure 5
POWER CONNECTION
CAUTION: You must use a Class II, 120 Volt AC/12 Volt DC adaptor that delivers at least 500mA.
The center tip must be positive and the plug must correctly fit the unit’s DC 12V jack.
1. Plug the AC adaptor into a standard AC outlet.
2. Insert the small plug inot the DC 12V jack on the rear of the base unit as shown in Figure 6.
.....................
.....................
.
.
3 15/16 55
(100mm)
(Figure 5)