User's Manual

SENTON Enterprises Limited 信 通 企 業 有 限 公 司
Flat 10, 17/F, Fo Tan Industrial Centre, 香港沙田火炭坳背灣街 26-28 號
26-28 Au Pui Wan Street, Fo Tan, Shatin, N.T., Hong Kong 富騰工業中心 17 樓 10 室
Tel: [phone] Fax: [phone] 電話: (八五二) 二六八七 一七一二 (四線)
E-mail address: [e-mail]
傳真: (八五二) 二六八七 四一二五
22 030206A-1
RECORDING THE OUTGOING MESSAGE (OGM) (The maximum recording time is 59 seconds.
The minimum recording time is 3 seconds)
1. In standby mode, Press the OGM button.
2. Press and hold the OGM button.
3. Record your greeting after you hear a beep tone.
4. Press the OGM button after you finish recording your greeting. Your recorded greeting will be
played.
CHECKING THE OUTGOING MESSAGE (OGM)
1. In standby mode, press the OGM button on the base unit to hear your previously recorded OGM.
2. You can stop OGM playback anytime during playback by pressing the PLAY/STOP button.
RECORDING A MEMO
Memo message(s) is recorded on the base unit. The maximum recording time is 1 minutes. The minimum
recording time is 3 seconds.
1. In standby mode, Press the MEMO button.
2. Press and hold the MEMO button.
3. Record your greeting after you hear a beep tone.
4. Press the PLAY/STOP button after you finish recording your greeting.
PLAYING BACK MESSAGE
If the NEW/MSG LED indicator is on, it indicates that you have Memo or ICM message(s). If it is
blinking, it indicates that there is new message(s). The blinking counts mean the number of new
messages.
A. PLAYING MESSAGES
In standby mode, press the PLAY/STOP button on the base unit. The 36028 will announce “You have
(number)(Memo) message.” And begins playing the first message to the end. It will announce the
message number before each message.
B. SKIPPING MESSAGES
Press the SKIP button on the base unit during message playback to skip forward to the next
message.
C. PREVIOUS MESSAGES
Press REPEAT button once on the base unit during message playback to skip backward one
message.
D. STOP MESSAGE PLAYBACK
Press the PLAY/STOP button to stop message playback.
ERASING MESSAGES
A. SELECTIVE ERASING
1. Press the ERASE button on the base unit during message playback.
2. The 36028 will announce “ (Message)(Memo)(Number) erased.” And then start the next message.
NOTE: Erased message can not be retrieved. There is a momentary delay after erasing messages to allow
the 36028 to reorganize and optimize its memory space.
B. ERASING ALL ICM AND MEMO
1. In standby mode, press and hold the ERASE button for about 2 seconds.
2. The 36028 will announce “Message (number) erased. You have no message.”
C. ERASING OGM
1. During OGM playback, press ERASE button.
2. The 36028 will announce “Erase your announcement. You have no announcement.”
NOTE: After erasing messages during memory full or near memory full, you may hear a continuous beep